TITEX " Yinuokesi " technology of broach of the high-speed steel that contain cobalt is characteristic

  • Time:
  • Click:38
  • source:PERFSO CNC Machining
TITEX rolled out broach of a kind of brand-new the high-speed steel that contain cobalt, basically use at processing stainless steel. It contains steeliness of cobaltic high speed to become by M35, the angle of geometry of point of a knife of its particular novel chamfer form, special design and use new workmanship, make this broach has wonderful laden capacity; TFT coating increased the wearability of broach further, can prevent edge to stick bits. Ginseng of 1 broach technology helps a figure 1 graph 2 graphs material of 3 cutting tool: HSS-CO M35 coating: , TINAL®FUTURA, TOP dimension: Limits of DIN338 standard diameter: Form of petiole of 3 ～ 12mm: Cylinder straight handle uses range: Treatment stainless steel, soft mild steel and copper alloy get pointed geometry figure: See a picture 1 ～ pursues 22 auger cut material of applied example workpiece: Stainless steel 1.

4571(316) workpiece parameter: Bore diameter Ø5mm, via, cooling fluid of hole depth 20mm: Chroma the emulsion cutting parameter of 6% : Vc=20m/min, f=0.

15mm broach life: Material of 1100 aperture workpiece: Stainless steel 1.

4571(316) workpiece parameter: Bore diameter Ø15mm, via, hole depth makes an appointment with 40mm cooling fluid: Chroma the emulsion cutting parameter of 6% : Vc=25m/min, f=0.

4mm broach life: 3 Yi Nuo overcomes 410 aperture this the life of broach and general Yao broach is comparative Yinuokesi (if the life contrast of workpiece of INOX) broach and stainless steel of common broach treatment pursues show 3 times. Model of graph 3 4 gets bits appearance to use Yinuokesi the scrap appearance when broach getting cuts stainless steel, low-alloy steel, cathode copper and aluminum-silicon alloy sees each pursue in next watches respectively. Aluminum-silicon alloy of cathode copper of low-alloy steel of workpiece material stainless steel is machined aperture parameter Ø8.

5mm deep 20mmØ8.

5mm deep 25mmØ8.

5mm deep 20mmØ8.

5mm deep 27mm cuts Vc=20m/minf=0 of parameter of bits configuration cutting.

16mmVc=43m/minf=0.

2mmVc=72m/minf=0.

1mmVc=90m/minf=0.

27mm CNC Milling